Heavy Duty Single Phase Magnetic Motor Starter For 220 Or 240 Volt Systems With Snap Trigger Switch Up To 4 Kilowatts And 5 Point 5 Horsepower Rated For Rock Solid Pump Operations

Heavy magnetic starter runs reliable pumps up to 240 volts.
✔️ 220 volt coil, 10 to 16 amps, under 4KW rating, thermal guard.

This magnetic motor starter gives you precise control over heavy equipment. You can mount it on air compressors, water pumps, or agricultural gear. The sturdy housing shields internal parts from workshop dust. You get smooth on and off operation with the dedicated button switch.

✅ Maximum power stays below four kilowatts for steady motor draws.
✅ Contact coil accepts standard twenty two to twenty four volt circuits.
✅ Working current runs ten to sixteen amps during active cycles.
✅ Built-in overload guards prevent winding failure across extended use.
✅ Sealed housing blocks debris while protecting your mechanical setup.

💡 Why should you choose a magnetic motor starter for your shop equipment?
- Thermal overload relays chop power right before windings fry during peak heat spikes.
- Auto trip circuits keep the contactor dead until you manually flip the reset switch back on.
- Super handy hookups save elbow grease and dollars when retrofitting stale compressor setups.
- Solid tripping margins stop expensive drive trains from taking hits during unexpected grid dips.

✝️