Rock Solid M10 Multi Grip Rivet Nuts 6 Pack Pre Bulbed Shank Flat Head Threaded Inserts For 304 Stainless Steel Metalworking And Serious Grind Projects

Precio habitual 57.95 Precio de oferta144.00Ahorras86.05
UPC:





M10 Stainless Rivet Nuts For Sheet Metal Fabrication 6 Pack
✔️ 304 Steel M10 Thread 13mm Hole 33mm Long Flat Head Design

You slide these flat head threaded inserts right into your shop gear. They bite hard into drilled holes to lock bolts onto thin panels. You will tack them down on workshop benches or garage racks. They forge ironclad anchor spots where screws tend to chew right through.

✅ 304 Stainless Steel body resists rust and takes daily abuse
✅ M10 thread size with a 1.5mm pitch mates with normal bolts
✅ 13mm drill hole width measures 0.51 inches for light gauge sheets
✅ 33mm overall length compresses to 16mm reading 0.63 inches inside
✅ Tolerates panel stock from 0.5 to 7mm thick crossing 0.02 to 0.28 inches

💡 What makes threaded inserts handy for fabricating sheet metal frames? You press them into place to build dependable screw anchors without tapping raw metal. - Drill a clean round hole matched to the 13mm shaft measuring 0.51 inches for a snug grip. - Drop the jack sleeve inside and yank the pull stud until the rear flange mushrooms flat. - This setup locks the collar dead so you stop stripping cheap threads under torque. - You swap fragile welded seams for removable bolt stations that carry serious weight.

✝️